A friend who owns a concrete mixing plant once told me that the belt of the conveyor slid location all the time. The same problem may be haunting many other people, too. To solve the problem, you should first figure out the reason for it.

A belt may slide because of several reasons. Sometimes the belt has been worn after long term usage. Check whether there are worn parts. If there are too many worn parts, you should consider exchanging the current belt with a new one. Quality of raw material for concrete also tend to cause sliding of the belt. Low quality sand of high moisture gets stuck onto carrier rollers easily, which makes the rollers slippery. Therefore, make sure that the rollers maintain clean all the time. Besides, the belt of frequently dismantled concrete plant is more likely to face sliding problem, because the frame gets deformed more easily during dismantling and installation. Even slight deformation has great influence on a moving belt. If, however, the problem goes with a new concrete mixing plant, it turns out to be easier to solve. Just adjust relative parameters until the belt stays in the middle.
Haomei concrete mixing plant has won more and more popularity in global market. Welcome to contact us at [email protected]  for more information.