Know about concrete equipment knows that, in the concrete equipment in use process, the side panel will appear the phenomenon of crack is one of the little not normal phenomenon, today we are manufacturer of professional people will introduce you to the cause of this phenomenon as well as the processing method, hope to help everyone had the same situation in the future can solve or avoid right quick.

Causes of cracks:

1. The fly ash (sand) is too fine to keep up with the early strength of the billet

2. The bulk density of the billet is large

3. The billet falls too hard

4. The billet body is not elastic enough under the water-material ratio

Solution:

1. (1) increase the cutting hardness; (2) increase the residual amount of fly ash sieve

2. (1) control capacity (2) use additives to improve the cutting strength of the billet

3. The blank body saw cutting table must stop at 10cm and then slowly fall down

4. (1) reduce the proportion of slurry (2) increase the amount of slurry (3) reduce the amount of lime

We mix concrete mixing plant manufacturers will introduce the garment on the various abnormal phenomenon occurring in a concrete equipment production and processing method, want to know the people pay attention to our website in time to update the content of the content, help you solve the problem as soon as possible or to avoid misunderstanding. I hope it helps.