drum concrete mixer is a kind of construction machinery, mainly used for mixing cement, sand, dry mortar and other building materials. This is a machine in which a shaft with a blade rotates in a cylinder or trough, mixing and mixing various materials to make it a mixture or suitable consistency. There are many kinds of mixer, such as forced type concrete mixer, single horizontal shaft mixer, double horizontal shaft concrete mixer and so on.
According to the shape of the agitator drum, there are five types: pear type, drum type, double cone type, disc vertical shaft type and circular groove horizontal shaft type. The first three systems are free-falling stirring; The latter two are forced mixing, which is rarely used in China.
Cylinder concrete mixers, also known as self-loading mixers, distinguish forced concrete mixers, concrete suitable for production of small construction sites, simple structure, wide adaptability, many users like this chapter, we take a closer look.
1. Before starting the rotating part and first checking whether there is any stirring tube scratch, adjust if scraping.
As shown in figure 2, the rotary agitator after the gearbox oil should be used in sequence, and the worm wheel is injected and the sliding bearing should be oil injected during unloading.
3. Clean the miscellaneous materials of the mixed pipe, the cylinder lock block, and then start the machine.
4. At the first stop of unloading, release the handle to limit the rotation of the handwheel. The worm wheel is driven by the rotation of the roller to the discharge position to stop the rotation.
As shown in figure 5, the roller hybrid source wiring must be correct, must have a reliable protection zero (or protective ground) and protection switch, wiring and drain edge of each part must meet the requirements.
6. Operators must be trained and passed the examination.
7. Operators must be clean, tighten, lubricate, adjust and maintain the mixer of employment law Cross meticulously every day.
8. Operators must concentrate, stick to their posts and leave their posts without permission. And should pay attention to the operation of the machine, in case of abnormal phenomena, the first storage tank after the inspection and maintenance stop discharge.
9. The abnormal phenomenon of components should be carefully checked. Drive clutch, brake and corresponding protection device are sensitive and reliable rope should be checked before damage, track, pulley is good, smooth body, surrounded channel, in order to confirm that there is a problem with the testing machine. After 2-3 minutes of operation, the roller will rotate smoothly, without pulsating or out of shape. In normal operation, it will sound before operation
10. In operation, repair and maintenance of drum mixer is prohibited, and the tool is not allowed to be extended to the feed tank.
11. The operation of the drum mixer is fed. In the course of a power failure, the material should be immediately discharged, allowed to stop midway and start reloading.
12, should not exceed the amount of material is strictly prohibited overload.
13. Drum mixer aggregate shall be strictly screened to prevent paper jam when large diameter must not exceed allowable value.
Figure 14. When the PLD1200 batching machine is checked in the drum mixer, it must be cut off. If necessary, it must be manned for drum maintenance.
15. The mixing pipe should be cleaned after use, and water should be poured into the mixer drum main shaft to clean the residual materials. Before leaving the scene, pull down the switch and sluice box.
16. Cleaning device if a long time after the end of the transmission components should contain oil treated in dry air.
17. After the work of the cold season, pumps, water discharge switch and water in the storage box must be cleaned to avoid freezing equipment.